PRODUCT DIRECTIONS:
SHAKE BEFORE USING. Vacuum thoroughly. For home use, follow directions for Portable Extraction.
PRE-SPRAY/EXTRACTION: For use on heavily soiled carpet traffic areas. Mix 4 oz. to 1 gallon of HOT, WARM or COLD water.
Let dwell for 5 to 10 minutes. Extract with fresh water.
To use as a rinsing agent: Mix 2 oz. to 5 gallons HOT, WARM, or COLD water in portable extractor.
PORTABLE EXTRACTION (without pre-spray): Mix 4 oz. to 1 gallon of HOT, WARM or COLD water. For all portable extractors
including extractors with a siphon tube. In this case, simply place the siphon tube into the concentrated liquid.
ENCAPSULATION PRE-SPRAY: Mix 4 oz. to 1 gallon of HOT, WARM or COLD water - agitate. After fiber dries, vacuum thoroughly.
BONNET CLEANING: Mix 4 oz. to 1 gallon of HOT, WARM or COLD water. Pre-spray evenly on heavily soiled area. Let dwell for
10 minutes. For best results, bonnet using 100% cotton bonnet pads.
WICKING & BROWNING: Mix 2 oz. to 1 gallon of HOT, WARM or COLD water. Pre-spray the carpet fiber. DO NOT OVER WET. Let dwell for 10 minutes. For best results bonnet using 100% cotton bonnet pads to prevent wicking or browning problems.
UPHOLSTERY: Mix 2 oz. to 1 gallon of HOT, WARM or COLD water. Apply from the base of the upholstery going up and extract.
HYDRO FORCE: Mix 32 oz. to 4 quarts of HOT or WARM water (meter 1:8). Let dwell for 5 to 10 minutes.
TRUCK MOUNT: Fresh water rinse. Set heat at 180° to 200° NOTE: Rinsing agents are not needed.